STEP 1: FIT THE BOTTOM & WALL LINERS.
WALL TO WALL SITUATION
Your kit contains:
- 1 x BOTTOM LINER for bottom track to sit on (in 2 pieces if run is longer than 2.5mtrs these need to be butted to each other)
- 2 X WALL LINERS
1.-Prepare the area by removing any coving that might be in the way of your wall liners as they will go all the way to the ceiling, do the same with the skirting if you want the wall liners to go to the floor (skirting boards are normally 18mm thick, same as your liners, so you might choose to cut them down to the skirting)
2.-Fit bottom liner
- Cut the bottom liner to size minus 2mm, drill 5mm holes (in the centre of the width of the liner) 500mm centres, place liner in position, check it is level and pack underneath as necessary, this is essential to ensure the smooth running of the doors.
- Fix bottom liner to floor with countersunk screws ensuring all the screwheads are flush with the surface of the liner
3.- Fit wall liners
- cut the wall liner to size minus 2mm, drill 5mm holes (in the centre of the width of the liner) 500mm centres, place liner in position, check it is vertical with a spirit level and pack behind the liner as necessary.
- Fix wall liner to wall with countersunk screws ensuring all the screwheads are flush with the surface of the liner
WALL TO END PANEL SITUATION
(ONLY READ THIS IF YOU HAVE ORDERED YOUR SLIDING WARDROBE KIT TO FIT BETWEEN THE WALL AND AN END PANEL)
1. Mark on the back wall the ordered width dimension ( the larger of the two measurements D & E from the HOW TO MEASURE page)
2.- Attach the fixing blocks provided, 4 to the back, 2 to top and bottom of the panel, making sure that they are flush with the edges, place panel against back wallcheck is vertical with a spirit level and secure, use small screws to screw the block into the panel and big screws to fix to the wall.
3.-Continue fitting the bottom and wall liners as per the WALL TO WALL SITUATION INSTRUCTIONS but remembering that your end panel works as one of your wall liners.
